Logo



   
Wood Burning Fireplace Piping
UL 127 Listed 2100 Degree High Temperature Piping




8" High Temperature Pipe & Accessories



ModelDescription
12-8HT12" Section of Double Wall Pipe
18-8HT18" Section of Double Wall Pipe
24-8HT24" Section of Double Wall Pipe
36-8HT36" Section of Double Wall Pipe
48-8HT48" Section of Double Wall Pipe
30E-8HT30 Degree Offset & Return Elbow Set
12S-8HT12" Chimney Support Pipe (For Systems Above 30')





8" Finishing Components For Standard & High Temp. Piping



ModelDescription
FS-8DM2" Clearance Firestop Spacer Required at Ceiling
(Standard 42" Models & 8" Multi View)
Firestop spacers are required at each point where the chimney penetrates a floor space. Their purpose is to establish and maintain the required clearance between the chimney and the combustible materials. They also provide complete separation from one floor space to
another or attic space as required by most codes.

30FS-8DM2" Clearance 30 Degree Firestop Spacer
3600FS-8DM-11" Clearance Firestop Spacer
(Standard 36" Models)
V6F-8DM0 to 6/12 Pitch Roof Flashing
(Use With RTL Terminations)
V12F-8DM6/12 to 12/12 Pitch Roof Flashing
(Use With RTL Terminations)
38FSTFirestop Thimble
(Use when penetrating a joist)
FST30Firestop Thimble
(Use when offsetting through a joist)
38RSRoof Support
(Use with flashing)
ADS-8DMAnti-Draft Shield
(Use With RTL or RTTL)





8" High Temperature Double Wall Termination



ModelDescription
RLT-8HT Round Top Termination
(Roof or Chase System - Use with all 8" systems)
4" Gain

RLTT-8HT Round Top Telescoping (Chase System Only)
1-17" Gain

ETL-8HTSquare Top  (Chase System Only)
1-12" Gain





Storm Collar



ModelDescription
SC1-1Storm Collar
(Use With RTL Terminations)





Important Heater Information



  • Installation must be done by qualified service persons.
  • Read Owner's Manual before using.
  • Not for use in recreational vehicles.
  • We reserve the right to amend product specifications without notice.
  • Use with adequate air (ventilation) only. Humidifies while it heats.
  • Provides water vapor in the area heated. Refer to owner's manual for specifics.
  • Heating areas based on rooms with 8' ceilings.
  • Operating heater at elevations above 4,500 ft. could cause nuisance outages.
  • ANSI Z21 11.2 Standard and National Fuel Gas Code revised in 1994 to permit wall mounted installations of vent-free gas heaters of 10,000 Btu or less in bedrooms and 6,000 Btu or less in Bathrooms. As always check local codes




Technical Tips

Replacement Parts

Home: Contact Us

© 1999--2014 New Beginnings Management Company, Inc.